In the example above, the /home directory is copied to the /opt/backup directory located on the local computer. The following command allows you to save a directory located on the server to your local computer: Scp -r /PATH /DIRECTORY ADDRESS:/PATH/target ~]# scp -r /mnt Save data from a local computer with Linux operating system To copy your server's data to another server using Secure Copy, type the following command in the shell: Secure Copy is a protocol for encrypted data transmission based on Secure Shell. Units = cylinders of 8 * 512 = 4096 bytesĭisk /dev/md8 doesn't contain a valid partition tableĢ heads, 4 sectors/track, 1222912 cylindersĭisk /dev/md7 doesn't contain a valid partition tableĭisk /dev/md6: 20.0 GB, 20012007424 bytesĢ heads, 4 sectors/track, 4885744 cylindersĭisk /dev/md6 doesn't contain a valid partition tableĭisk /dev/md5 doesn't contain a valid partition tableĢ heads, 4 sectors/track, 246960 cylindersĭisk /dev/md1 doesn't contain a valid partition tableĬopy data to another server with Linux operating system using Secure Copy dev/sdb 19543041 fd Linux raid autodetect dev/sda 19543041 fd Linux raid autodetect This command writes the log entries to a file.Įxample: arcconf getlogs 1 device tabular > device.logĭisk /dev/sda: 250.0 GB, 250059350016 bytesĢ55 heads, 63 sectors/track, 30401 cylinders Tabular: Displays the log in table format.Ĭlear: Deletes the specified controller protocol.Īrcconf getlogs controller-number device ¦ dead ¦ event > FILENAME.log You can also specify the following parameters: You can use the following parameters to specify the type of log entries displayed:Įxample: arcconf getlogs 1 device tabularĭEVICE: Shows all log entries with errors the controller could detect on all connected devices.ĭEAD: Shows all log entries where device and hard disk failures were recorded.ĮVENT: Shows all log entries with information about special events (e.g. Use this command to display the log entries. Use this command to display information about the existing hard disks.Īrcconf getlogscontroller-number device ¦ dead ¦ event This command displays information about the RAID controller, configuration, RAID arrays, available disks and their current state.

Use the commands listed below to access hardware RAID and configuration information: Adaptec RAID Controller

Directory for usb linux rescue